Home > Debian Jessie > Debian Squeeze Radeon Drivers

Debian Squeeze Radeon Drivers

Contents

NOTE: This no longer works on Wheezy/testing or Sid after upgrade to Xserver 1.12. This service is sponsored by Hewlett-Packard. For 3D acceleration to work, you will need to compile the fglrx kernel module for your kernel: see the fglrx-modules-dkms package. Debian is a trademark of SPI Inc. http://jcibook.net/debian-jessie/debian-drivers-radeon.html

For other contact information, see the Debian contact page. Before Starting[edit] If you have previously attempted installing Catalyst, remove any leftover files by following the Removing the Driver section. Note 2: fglrx version 13.4 works just fine except changing the brighntess because it stays full all the time. However, the Catalyst 9-3 driver doesn't support X servers past 1.5, and it will not work with Debian versions later than Lenny/5.0.x!!!!SO BE CAREFUL!!! https://wiki.debian.org/ATIProprietary

Debian Jessie Radeon Driver

This guide focuses on installing the proprietary ATI driver (fglrx/Catalyst). Building the kernel module has been tested up to Linux 4.2. This library is shipped in the libgl1-fglrx-glx package. So, you have two options: 1) Downgrade from xserver 1.12 (Tested, and works on Debian Wheezy kernel 3.2.0-4-amd64

  1. Debian From cchtml.com Jump to: navigation, search Contents 1 Read Me First 2 Read Me Second:SLEEP mode in Debian/testing kernel 3.2.0 3 Installation 3.1 Before Starting 3.2 Installing from Debian Repository
  2. sudo dpkg-buildpackage -us -uc cd ..
  3. Other Packages Related to fglrx-driver depends recommends suggests enhances dep: debconf (>= 0.5) Debian configuration management system or debconf-2.0 virtual package provided by cdebconf, cdebconf-udeb, debconf dep: glx-alternative-fglrx (>= 0.4.1~) allows
  4. The following subsections will attempt to address possible (and tested) variations for their respective configurations.
  5. The following chips should be supported: R100, RV100, RS100, RV200, RS200, RS250, R200, RV250, RV280, RS300, RS350, RS400/RS480, R300, R350, R360, RV350, RV360, RV370, RV380, RV410, R420, R423/R430, R480/R481, RV505/RV515/RV516/RV550, R520,
  6. dpkg -i *.deb Wheezy AKA OLDSTABLE Installation (current as of May 3, 2013)[edit] Why someone posted this I do not have any idea 12.6 was shipped with Wheezy from day one,there
  7. If your card is on that list, you are limited to open-source drivers on Debian Squeeze/6.0 (and later).
  8. More information about X.Org can be found at: This package is built from the X.org xf86-video-ati driver module.
  9. At the time of making this edit beta version 12.6 also works just fine.
  10. Unfortunately fglrx/Catalyst trigger segfaults in Xorg newer than 1.11.x, and the driver was removed from Wheezy and Sid.

So i first install last fglrx-atieventsd packet and over it amd-driver-installer-catalyst-12.10-x86.x86_64.run. ( Or first amd-driver-installer-catalyst-12.10-x86.x86_64.run and then manualy copy rest conf files from fglrx-atieventsd without overwriting.) Then start atieventsd: "service fglrx-atieventsd This package provides display drivers and hardware accelerated OpenGL for X.Org. However you can manually install the 13.11 beta 6 version. [Note: As of 2016-02-27, fglrx packages appear in Jessie repos.] mkdir ati cd ati apt-get build-dep fglrx-driver apt-get -b source fglrx-driver Debian Amdgpu This method uses the latest Catalyst driver downloaded from AMD/ATI's site.

Prerequisite Packages[edit] Install the prerequisite packages (names are based on Debian sid, older Debians may be different): $ sudo apt-get install build-essential cdbs fakeroot dh-make debhelper debconf libstdc++6 dkms libqtgui4 wget Debian Jessie Fglrx Installing this driver will not show up the watermark 2) Patch libpciaccess (I have no first hand knowledge of this working but others swear by it) This will get you the Learn more about this site. In this case you must execute: mkdir ati cd ati sudo apt-get build-dep fglrx-driver sudo apt-get source fglrx-driver cd fglrx-driver-* Edit file `debian/rules.defs` and adds 19 into XORG_ABI_LIST list.

If you really need the proprietary Catalyst/fglrx driver, you will have to use Debian Lenny/5.0.x and install Catalyst 9-3. Debian Stretch Fglrx This driver release supports the following graphics adapter families: AMD Radeon R9 Series, AMD Radeon R7 Series, AMD Radeon R5 Series, A-Series AMD Radeon R7/R6/R5/R4/R3 Graphics, E-Series AMD Radeon R2 Graphics, To force the ATI driver to adopt changes made to xorg.conf, use the following command: $ sudo aticonfig --input=/etc/X11/xorg.conf --tls=1 Test your installation[edit] NOTE: if you don't reboot first, fglrxinfo gives To avoid confusion with the Xorg configuration, you may want to delete /etc/X11/xorg.conf file and use the following command to have it generated (assuming 2 monitors per card): prompt$ aticonfig --initial

Debian Jessie Fglrx

Note 1: In the linked directions they use fglrx version 12.4. New version amd-driver-installer-catalyst-13.1-linux-x86.x86_64.run and fglrx-driver_12-6+point-1_i386.deb i havenot test. Debian Jessie Radeon Driver The driver can work with plain MESA libGL, but some applications may require the proprietary libGL. Xserver-xorg-video-radeon Multiple monitors on one card AND a monitor attached to VGA port. 2.

If you tried to install Catalyst on a system with one of these cards, see the 'Removing the Driver' section to restore the default/pre-installed drivers. Check This Out See the complete list here. Using fglrxinfo on a system with Catalyst 11-4 and a RadeonHD 4250 returns: display::0.0 screen: 0 OpenGL vendor string: ATI Technologies Inc. Content Copyright © 1997 - 2017 SPI Inc.; See license terms. Firmware-linux-nonfree

skip the navigation Packages About Debian Getting Debian Support Developers'Corner / Packages / jessie (stable) / x11 / fglrx-driver package names descriptions source package names package contents all options [ wheezy Follow the Removing the Driver section below to remove your existing driver. This service is sponsored by Hewlett-Packard. Source Learn more about this site.

If you do not have non-free enabled, you can do so like this: http://serverfault.com/questions/240920/how-do-i-enable-non-free-packages-on-debian $ sudo apt-get remove --purge xserver-xorg-video-radeon $ sudo apt-get install fglrx-driver fglrx-control libgl1-fglrx-glx fglrx-atieventsd fglrx-modules-dkms If you Amd Catalyst Debian Jessie More than one card. ...you may encounter problems that the resolution of the first monitor on the first card (usually identified as "CRT-1") may (a) not be recognized by manufacturer/model and Learn more about this site.

Use the following as a starting point: Section "ServerLayout" Identifier "amdconfig Layout" Screen 0 "amdconfig-Screen[0]-0" 0 0 EndSection Section "Module" EndSection Section "Monitor" Identifier "0-DFP6" Option "DPMS" "true" Option "PreferredMode" "1920x1080"

I find it odd this all got added after Wheezy was released with 12.6,because I was here and posted the info,and this post wasnt here, Do you work for Nvidia? ATTENTION RADEON USERS NOTE: If you enter your card information on AMD/ATI's driver page, it will offer you the Catalyst 9-3 driver to download. please refer the Discussion for details.... Fglrx-driver Clean install amd-driver-installer-catalyst-12.10-x86.x86_64.run on Debian/testing kernel 3.2.0 i386.

Tags: System Administration: Hardware Support, Hardware Enablement: Graphics and Video, Implemented in: C, Role: role::plugin, use::driver, X Window System: X Server and Drivers Other Packages Related to xserver-xorg-video-radeon depends recommends suggests For multiple monitors, instead try specifying all monitors in your xorg.conf file. Tags: System Administration: Hardware Support, Hardware Enablement: Graphics and Video, Implemented in: C, Role: role::plugin, use::driver, X Window System: X Server and Drivers Other Packages Related to xserver-xorg-video-radeon depends recommends suggests have a peek here Old version have made problems with wine games , something like "malloc() corruption memory" and segfault.

Content Copyright © 1997 - 2017 SPI Inc.; See license terms. If this happens, check if the log file /var/log/Xorg.0.log contains an entry like this one: (II) fglrx(0): Cannot get EDID information for CRT1 ...which may be followed later with: (II) fglrx(0): Add backports to your sources.list Add this line deb http://backports.debian.org/debian-backports squeeze-backports main contrib non-free to your sources.list (or add a new file to /etc/apt/sources.list.d/) $ sudo apt-get update $ sudo apt-get Installation[edit] The open-source ati/radeon driver should already be installed and used as the default.

Read Me Second:SLEEP mode in Debian/testing kernel 3.2.0[edit] amd-driver-installer-catalyst-12.10-x86.x86_64.run breaks sleeping mode(notebook hangs up after awaking and reboot without logging anything ). For other contact information, see the Debian contact page.